Spinning; Final Spin Speed In The Programme; Interim Spin; Omitting The Final Spin (Rinse Hold) - Miele WCE 660 Operating Instructions Manual

Final spin speed in the
programme
When a programme is selected, the
optimum spin speed for this wash
programme is shown in the display.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme
Cottons
Minimum iron
Delicates
Woollens 
Silks 
Shirts
Express 20
Dark garments / Denim
Outerwear
Proofing
Sportswear
Automatic plus
Separate rinse/Starch
Drain / Spin
Clean machine

Interim spin

There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate.
Omitting the final spin (Rinse
hold)
If Rinse hold is selected, the laundry
remains in the water following the final
rinse cycle. This helps prevent creasing
if the laundry is not going to be
removed from the drum immediately
after the end of the programme.
 Set the spin speed
To start the final spin
rpm
The washing machine will display the
1400
maximum spin speed possible. You can
1200
reduce the spin speed.
900
 Touch the Start/Stop sensor.
1200
To end the wash programme
600
Select this option if you want to remove
900
the laundry when it is dripping wet and
1200
without spinning.
1200
 Reduce the spin speed to
800
 Touch the Start/Stop sensor.
1000
The water will be pumped away.
1200
1400
Omitting the interim spin and
1400
the final spin
1400
 Before the start of the wash
900
programme, reduce the spin speed to
.
0
 Touch the Start/Stop sensor.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.

Spinning

.

0 .
39