Before using for the first time
Settings for compartment
The UltraPhase 2 values are pre-set in
the standard settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for
Confirm with the OK sensor.
Miele UltraPhase 2
Confirm with the OK sensor.
The dispensing quantity for
UltraPhase 2 is pre-set for
(hardness range II).
Per load
Confirm the pre-set value with the OK
sensor or correct the value with the
sensors and confirm this with the
OK sensor.
UltraPhase 2
Hardness level I
Hardness level II
Hardness level III
22
OK
OK
45
ml
OK
36 ml
45 ml
54 ml
The following will appear in the display:
Insert
Remove the film from the detergent
cartridge.
Push the UltraPhase 2 detergent
cartridge into compartment 2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
"TwinDos" is set. Can be changed in
"Settings".
Confirm with the OK sensor.
Close the TwinDos access panel.