Table of Contents
Advertisement
Auto Off function
You can either place the fusion wand in the holder or you can press the green button for
three seconds, the repair station will go into dormant state. The heater is turned off, the
air flow goes to the maximum flow and the heater core is quickly cooled below 212°F,
the screen shows a display of the moon. After the cooling cycle is complete, the fan
stops running, and the repair station goes into a hibernation mode. To restart, press the
wand button and cycle to the desired heat setting. Optionally, remove the fusion wand
from the stand and it will start automatically.
Temporary Power Down Mode
Press the button on the fusion wand for at least 3 seconds or set the fusion wand in its
stand. The heating element turns off and the cooling cycle begins, (indicated by the
presence of the "snowflake‟ icon on the left of the screen). As the fusion wand cools
down below 212°F, the icon will change to a half moon icon and the station will be in
standby mode. The system will remain in this temporary power down state indefinitely,
until the user removes the fusion wand from the stand.
CAUTION:
The tip and barrel of the fusion wand will cause serious burns if they are
allowed to contact the skin. Always return the fusion wand to the docking cradle after
each use. Plastic welders operate at high temperatures and can easily burn people or
objects. Do not touch the tip and heater at any time and keep it a safe distance from
flammable materials while the unit is on or while it's cooling. Please allow a sufficient
time for the unit to cool before changing tips!
Faster. Smarter. Better.
REMEMBER, THE TIP IS HOT.
8
Advertisement
Table of Contents
