PRODUCT DESCRIPTION The FUSION Plus+ Plastic Repair Station is the industry’s first completely microprocessor controlled plastic welding station. No knobs, no flow gauges, no worries. To begin welding, remove the welding wand from its docking cradle and the Fusion Plus+ welder will auto-start. Using the fingertip control switch conveniently located on the wand, select the desired welding temperature setting and the welder rapidly heats up.
To Prevent Electrical Shock, Be Sure To Take The Following Precautions: 1. Make sure the unit is grounded. Always connect power to a grounded receptacle. 2. Do not stress the AC power cord. 3. Do not bump, hit, pour water/liquids or otherwise subject the fusion wand to physical shock.
PRODUCT FEATURES • The solid state Fusion Plus+ electronic module features an intuitive lighted LCD touch screen display and precision microprocessor controlled heat/flow settings. • A temperature sensor installed inside the heating element of the wand provides fast and accurate temperature control directly at the tip. •...
**From any preset CH setting, just tap the adjust temperature arrows and the CH0 ‘default’ activates and remains the default channel for temperature control unless a channel preset is again activated by pressing the white button. OPERATING PROCEDURES 1. Ensure that the base unit power switch is in the “OFF” position. 2.
CH1. Temperature 302°F / Air Flow 100, CH2. Temperature 572°F / Air flow volume 120, CH3. Temperature 842°F / Air flow 180 PROGRAMMING CH1 to CH3 are the three programmable settings To set: Hold down the SET button on the screen and the green button on the wand handle simultaneously for two seconds.
Auto Off function You can either place the fusion wand in the holder or you can press the green button for three seconds, the repair station will go into dormant state. The heater is turned off, the air flow goes to the maximum flow and the heater core is quickly cooled below 212°F, the screen shows a display of the moon.
Performing a repair Please visit www.youtube.com and search for Fusion Plus Plastic Welder for step by step introduction on how to use this unit. If you have no access to the internet, please use the step by step instruction found below: Pre-Operation: Clean the repair area with warm soapy and water, and/or plastic cleaner 2.
Page 10
12. Remove the aluminum body tape on the front. 13. Confirm that the repair area is clean. 14. On the front side, sand the repair area with the recommended grit. 15. Use a grinder, taper in a V-shaped groove on the front side of the repair. 16.