Table of Contents
Advertisement
PRODUCT DESCRIPTION
The FUSION Plus+ Plastic Repair Station is the industry's first completely
microprocessor controlled plastic welding station. No knobs, no flow gauges, no
worries. To begin welding, remove the welding wand from its docking cradle and the
Fusion Plus+ welder will auto-start. Using the fingertip control switch conveniently
located on the wand, select the desired welding temperature setting and the welder
rapidly heats up. You are now ready to weld. When welding operations are complete,
return the Wand to the docking cradle and the system cycles off and goes into sleep
mode automatically.
This tool is specifically designed for plastic repair using precision temperature control.
Please read the operating manual prior to use to familiarize yourself with the features
and safe operation of the system.
INTRODUCTION
The head of the Fusion wand gets extremely hot during use and caution should be
taken to avoid injuries or damage to objects that may come in contact with the tip. Be
sure to comply with the following warnings and cautions for your safety.
1. Power to the unit should be 110VAC.
2. Prior to use, check the unit for any shipping damage.
3. During operation, the head of the Fusion wand is extremely hot and will cause
serious burns if it makes contact with exposed skin.
4. Do not use the product near combustible gases or flammable materials.
5. Turn the power switch OFF and allow the unit to cool prior to storing the unit.
6. Keep the Fusion Pro clean. Use a damp cloth and a small amount of liquid
detergent. Never submerge the unit in liquid or allow any liquid to enter the station.
Never use any solvent to clean the case.
7. This unit is designed specifically for plastic welding and should not be used for any
other purpose.
8. Fire may be a result if the system is not used safely:
• Be careful when using the Fusion Pro in places where there are combustible
materials;
• Do not use in the presence of combustible materials;
• Be aware that heat may be conducted to combustible materials that are out of
sight;
• Place the Fusion Plus+ wand in its stand after use and allow it to cool down
before storage;
• Do not leave the Fusion Pro unattended when it is switched on.
9. Make sure the work area is well ventilated.
Faster. Smarter. Better.
Simple, precise, powerful...
3
Advertisement
Table of Contents
