Table of Contents
Advertisement
operating your urn
Before first use
Remove all packaging from the urn.
It is recommended you clean your urn before the first use.
Fill the urn with water to the 'MAX' level, boil, discard the water, and then rinse. Repeat the
procedure several times to remove any dust, residues, etc., from the urn.
Follow these quick steps before using the urn:
•
Fully extend the power cord.
•
Place the urn on a dry, stable and level, heat resistant surface.
•
Remove the lid and fill the urn to the 'MAX' line - turn the lid anti-clockwise and to disengage
it from the urn.
•
After filling the urn, refit the lid and turn clockwise to lock into place.
•
Plug the power cord into the wall power outlet and switch it on.
•
Set the On/Off switch to On, the "Heating" light will illuminate.
•
Wait for the water to reach temperature, the "Heating" light will go out and the "Hot" light
will illuminate.
•
Set the On/Off switch to Off. Switch off the power and remove the plug from the wall power outlet.
•
Drain the urn of all the water using the tap.
Note: Take care when pouring as the water is hot!
•
There will be some water left in the bottom of the urn. Check that both the urn and the
remaining water have cooled to a safe handling temperature. Carefully lift the urn and
pour out the remaining water.
•
Rinse out the urn with fresh water.
HoW to use
•
Turn the urn lid anti-clockwise to open. Lift off the lid, and fill with water. Make sure the water
is at or below the 'MAX' water level indicator. To close, refit the lid and turn it clockwise to
lock it into place.
Note: The lid should always be locked in place when in use.
•
Plug the power cord into the wall power outlet and switch it on.
•
Set the On/Off switch to the On position. The "Heating" light will illuminate and the water will
start to heat up. When the water has reached temperature, the "Heating" light will go out and
the "Hot" light will illuminate. The light will toggle between "Hot" and "Heating" as the
thermostat cycles.
•
To pour hot water, place a cup under the water tap and press down on the tap lever.
Note: The tap lever will stay down.
•
Lift the tap lever once you have dispensed the required amount of water.
Note: Always empty the urn before moving it. Never carry or move the urn when it is in operation
or while it is hot.
Use caution when pouring water from the urn, as boiling water will scald.
When in use, steam may escape from the steam holes on top of the urn. Use caution at all times.
Advertisement
Table of Contents
