Setting The Time Data; Setting The Timecode - Sony HANDYCAM PMW-350K Operating Instructions Manual

Setting
Side4
Front
Front+Side4
You can now adjust the levels of audio
channels 3 and 4 with the knobs selected
here.
62

Setting the Time Data

Knob
LEVEL (CH4) knob
MIC LEVEL knob
LEVEL (CH4) knob and
MIC LEVEL knob (linked
operation)
Setting the Time Data
Note
When picture cache mode is enabled, it is not possible to
set time data, even if you set the F-RUN/SET/R-RUN
switch to SET. If you want to set time data, first exit
picture cache mode.

Setting the Timecode

The timecode setting range is from 00 : 00 : 00 :
00 to 23 : 59 : 59 : 29 (hours : minutes : seconds :
frames).
1
Set the DISPLAY switch to TC.
2
Set the PRESET/REGEN/CLOCK
switch to PRESET.
3
Set the F-RUN/SET/R-RUN switch to
SET.
The first (leftmost) digit of timecode flashes.
4
Use the up and down arrow buttons to
change values, and use the left and right
arrow buttons to move the flashing
digit. Repeat until all digits are set.
To reset the timecode value to 00:00:00:00
Press the RESET/RETURN button.
5
Set the F-RUN/SET/R-RUN switch to
F-RUN or R-RUN.
F-RUN: Free run. The timecode generator
keeps running.
R-RUN: Recording run. The timecode
generator runs only while recording.
To set the drop frame mode/non-drop frame
mode
You can select the drop frame (DF) mode or non-
drop frame (NDF) mode on MAINTENANCE
>Timecode in the setup menu.