Starting To Record From Pre-Stored Video (Picture Cache Function) - Sony HANDYCAM PMW-350K Operating Instructions Manual

details, see "Adding and Deleting OK Marks (HD
Mode Only)" (page 87).
To set OK marks
After recording of a clip ends, turn on the
assignable switch to which the OK Mark function
has been assigned (see page 131). If the OK Mark
function has been assigned to the RET button on
the lens, press RET button on the lens.
An OK mark is set in the most recently recorded
clip, and an "OK Mark" indication appears in the
viewfinder for about three seconds near the
timecode indication.
To delete OK marks
1
If an OK mark has been set in the most
recently recorded clip, turn on the
assignable switch to which the OK
Mark function has been assigned (see
page 131).
If the OK Mark function has been
assigned to the RET button on the lens,
press RET button on the lens.
A confirmation message appears.
2
Turn the MENU knob to select
[Execute], and then press the knob.
The OK mark is deleted from the most
recently recorded clip.
Starting to Record from Pre-
stored Video (Picture Cache
Function)
The camcorder is equipped with enough internal
memory to pre-store up to 15 seconds of video
and audio data in a picture cache. This allows you
to begin recording a specified number of seconds
in advance of the time when you press a recording
start button.
Selecting picture cache mode and setting
the picture cache time
Before recording in picture cache mode, you must
select picture cache mode and set the picture
cache time (the number of seconds of video and
audio data stored to memory) in the
OPERATION menu.
The picture cache time determines how far in
advance you can start recording, counting back in
seconds from the operation that starts recording.
74 Advanced Operations
Note that it may not be possible to start this far in
advance in the special cases explained in the
following notes.
Notes
• Storage of picture data to memory begins when you
select picture cache mode. Therefore, if you start
recording immediately after selecting picture cache
mode, the picture data from before the selection is not
recorded.
• No data is recorded to picture cache memory during
playback or recording review and display of
thumbnails. It is not possible to record picture data
from the time you were conducting playback or a
recording review.
To select picture cache mode and set the picture
cache time
Notes
• Picture cache recording is not possible in Frame Rec,
Interval Rec, and Slow & Quick Motion mode. The
camcorder exits Frame Rec, Interval Rec, or Slow &
Quick Motion mode whenever you select picture cache
mode. The camcorder exits picture cache mode
automatically whenever you select Frame Rec,
Interval Rec, or Slow & Quick Motion mode.
• The data stored in picture cache memory is cleared
when you change the system settings, for example by
selecting a different video format. Picture data from
before the change is not recorded even if you start
recording immediately after the change. The
camcorder exits picture cache mode automatically.
• It is not possible to set the picture cache time during
recording.
1
In the setup menu, select OPERATION
>Rec Function >Picture Cache Rec.
For menu operations, see "Basic Setup Menu
Operations" (page 94).
2
Turn the MENU knob to select [On],
and then press the knob.
3
Select [P. Cache Rec Time], turn the
MENU knob to select the desired
picture cache time, and then press the
knob.
You can select from 0-2sec, 2-4sec, 4-6sec,
6-8sec, 8-10sec, 10-12sec, 12-14sec, and
13-15sec.
Once made, picture cache mode settings remain
in effect until changed.
Instead of carrying out steps
select picture cache mode by using an assignable
1 and 2, you can also