Deleting Recorded Clips; Advanced Operations; Recording Shot Marks; Setting Ok Marks - Sony HANDYCAM PMW-350K Operating Instructions Manual

To play at high speed
Press the F FWD button (see page 20) or the
F REV button (see page 20).
To return to normal playback, press the PLAY/
PAUSE button.
To switch between memory cards
When two memory cards are loaded, press the
SLOT SELECT button (see page 23) to select the
active slot.
It is not possible to switch between memory cards
during playback.
To end playback
Press the STOP button: Playback stops, and the
camcorder enters E-E mode.
Press the THUMBNAIL button: Playback
stops, and a thumbnail screen (see page 80)
appears in the viewfinder.
Playback also stops and the timecode screen
appears in the viewfinder when you start
recording during playback, and when you eject an
S×S memory card.

Deleting Recorded Clips

You can use the assignable switches to delete the
last recorded clips (Last Clip DEL function).
You can also use the THUMBNAIL menu to delete all
recorded clips (All Clips DEL function) or to delete
selected clips. For details, see "Deleting Clips"
(page 88).
1
Turn on the assignable switch to which
the Last Clip DEL function has been
assigned (see page 132).
A confirmation message appears.
2
Turn the MENU knob to select
[Execute], and then press the knob. Or
use the J or j button to select
[Execute], and then press the SET
button.

Advanced Operations

Recording Shot Marks

On this camcorder, two types of shot marks are
available in HD mode. You can record them at
user-specified positions to make it easier for
editors to cue up those positions. You can record
up to 127 shot marks per clip.
Note
Shot marks cannot be recorded in SD mode.
You can also use the THUMBNAIL menu to add and
delete shot marks in clips. For details, see "Adding
and Deleting Shot Marks (HD Mode Only)"
(page 90).
To record shot marks
Do one of the following.
• Turn on an assignable switch to which Shot
Mark 1 or Shot Mark 2 has been assigned (see
page 131).
• If Lens RET has been assigned to the RET
button on the lens, operate as follows.
To record Shot Mark 1: Press the RET button
once.
To record Shot Mark 2: Press the RET button
twice in quick succession.
When a shot mark is recorded, a "Shot Mark 1" or
"Shot Mark 2" indication appears in the
viewfinder for about three seconds near the
timecode indication.

Setting OK Marks

To make it easier for editors to select good clips,
you can set OK marks in clips recorded in HD
mode.
Notes
• OK marks cannot be set in SD mode.
• OK marks cannot be set or deleted during recording or
playback.
You can also use the THUMBNAIL menu to add and
delete OK marks in previously recorded clips. For
Advanced Operations 73