General Settings - almando Multiplay Surround Decoder Installation And Operating Instructions Manual

General Settings

On this page you make general settings and have the possibility to reset the device to
the factory defaults or to update the firmware.
Here you determine whether data
signals will be sent to the B&O
speakers (input data from connected
B&O devices or data generated by the
almando Decoder itself for third-party
devices). This is only necessary if
BeoLab 5, BeoLab 4500 or BeoLab
Penta are connected. Otherwise the
generation of the "data signal" should
remain deactivated (default setting).
Only if a subwoofer from Loewe is
connected, the trigger voltage may be
switched to the
Attention: for B&O subwoofers this
switch must be disabled - otherwise
they could be damaged.
With this switch you can set whether
the device at the input DIN (B&O
Powerlink) provides a trigger voltage.
Usually a B&O device is connected to
this input. Therefore this switch is
activated (default setting). If a non-
B&O device is connected to this input
(e.g. Sonos Connect, turntable, etc.),
which can only be operated with
automatic signal detection, then this
switch must
Incidentally, this also applies to the
following two B&O devices: BeoSound
Essence and BeoSound Moment -
please deactivate this switch as well.
required 10V.
be deactivated.
15