General Settings - almando Multiplay Surround Decoder Installation And Operating Instructions Manual

General Settings

On this page you can make global settings. You also have the possibility to reset the
device to the factory settings and to update the firmware of the almando Multiplay
Surround Decoder.
16
Use this button to return to the main
page of the App.
Here, you determine whether data
signals will be sent to the B&O
speakers (input data from connected
B&O devices or data generated by the
almando Decoder itself for third-party
devices). This is only necessary if
BeoLab 5, BeoLab 4500 or BeoLab
Penta are connected. Otherwise the
generation of the "data signal" should
remain deactivated (default setting).
If no devices are connected to certain
inputs, these should be deactivated
here. They are then dimmed on the
main page of the app. This setting can
be reversed at any time later.
In the lower area there is a button for
resetting the device to the factory
settings (delivery state). The current
firmware status is also displayed.