Valeo THERMO PLUS 300 Operating And Service Instructions
  1. Manuals
  2. Brands
  3. Valeo Manuals
  4. Heating System
  5. thermo plus 300
  6. Operating and service instructions

Valeo THERMO PLUS 300 Operating And Service Instructions

Hide thumbs Also See for THERMO PLUS 300:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

HEATING SYSTEMS
THERMO PLUS
230/300/350
Operating and
service instructions
NOTE: Subject to modification. In multilingual
versions the German language is binding. The
latest version of this document is provided for
download on www.valeo-thermalbus.com.
Rev. 05/2018
Id.No. 11121148B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the THERMO PLUS 300 and is the answer not in the manual?

Questions and answers

Related Manuals for Valeo THERMO PLUS 300

Summary of Contents for Valeo THERMO PLUS 300

  • Page 1 HEATING SYSTEMS THERMO PLUS 230/300/350 Operating and service instructions NOTE: Subject to modification. In multilingual versions the German language is binding. The latest version of this document is provided for download on www.valeo-thermalbus.com. Rev. 05/2018 Id.No. 11121148B...

  • Page 2: General Information

    1500 m above MSL and up to 2000 m above MSL if that is a short stay in such conditions (pass crossing, break). In case of a permanent heater operation above 1500m the CO setting must be readjusted by Valeo trained personnel, due to a change of the exhaust gas values depending on environmental conditions. Service and safety instructions For the heater exist type approvals according to ECE Regulations R122 (Heater) and R10 (EMC).
  • Page 3 An up-to-date list of anti-freeze approved by Valeo can be found on the Valeo website. The heater must: with a diesel fuel approved by Valeo in accordance with DIN EN 590 (see TI's Fuels on the Valeo website for more information) and the rated voltage shown on the model plate.

  • Page 4: Heater Operation

    Operating and service instructions Heater operation The water heater can be switched on using either a switch or digital timer. Before you switch on the heater set the vehicle's heating system to “Warm”. Pre-selection timer 1 Menu button 9 10 2 Selection button UP 3 Instant heating button 4 Confirmation button...
  • Page 5 Thermo Plus 230/300/350 the week, the hours and the minutes. Switch the preselection timer off Confirm each respectively using - switch off ignition (the preselection timer Note: In the 12h mode, after setting of the goes into the sleep mode) minutes, further choose AM or PM by the - the timer turns off after the expiry of selection buttons - confirm using...
  • Page 6 Additional to the fault lock-out a heater lock-out occurs if safety related components are affected. The fault code 12 will be displayed (see para. “Flash code“). If a heater lock-out has occurred, the heater must be maintained and released by Valeo trained personnel.

  • Page 7: Flash Code

    Thermo Plus 230/300/350 Flash code The kind of malfunction is indicated from the operating indication light through a flash code or if the pre-selection timer is used in the display (operation display). The flash code is immediately generated after detection of the malfunction and will be kept until the heater is freed.
  • Page 8 Valeo Thermal Commercial Vehicles Germany GmbH Friedrichshafener Str. 7 - 82205 Gilching - Germany Tel. +49 (0)8105 7721-0 Fax +49 (0)8105 7721-889 www.valeo-thermalbus.com - service-valeobus@valeo.com...

This manual is also suitable for:

Thermo plus 230Thermo plus 350

Table of Contents

Save PDF