Table of Contents
Advertisement
PREPARING YOUR DISTILLER AND RESERVOIR
CAUTION: To prevent personal injury or property damage, do
not plug distiller into wall outlet until all parts have been
cleaned and properly installed.
INITIAL CLEANING
Before using your distiller and reservoir for the rst time, follow
the steps below.
Boiling Chamber
Do not immerse boiling chamber in water or other liquid for cleaning.
Using a sponge or cloth, clean the interior of the boiling chamber with hot
soapy water . Rinse thoroughly with fresh water. Be sure the gasket is properly
and securely placed over the top rim of the boiling chamber before using
the distiller.
Reservoir
Clean the inside of the reservoir tank with either vinegar or a paste made of
baking soda and water to remove any traces of manufacturing oils. Rinse
thoroughly with fresh water.
It is recommended you steam clean your distiller and reservoir prior
to using it for the rst time. Complete this step AFTER the unit is
completely assembled (see pages 7-14) . This is a disinfecting procedure.
Steam Cleaning Instructions
1) Remove the post carbon lter.
2) Be certain that the FAN switch is in the OFF position, then turn ON
the switch for the POWER only. You should hear the water begin to
ll the boiling chamber.
3) When su cient water lls the boiling chamber the heating element
will turn on automatically. After 15 minutes you should notice steam
beginning to appear in the sight gauge.
4) Continue steaming the unit for approximately 20 minutes.
CAUTION:
External surfaces will be HOT during this process.
DO NOT TOUCH UNIT!
5) Turn OFF the POWER switch and allow the unit to cool completely.
6) When the unit has cooled completely, put the post carbon lter
back in place.
7) Check all components, then turn ON both the FAN and POWER
switches.
6
Advertisement
Table of Contents
