General Setup; Using Your Edge Tm Rf; On/Off And Auto Off - Volfoni Edge RF VPEG-03210 User Manual

3.2 General setup

- Choose a compatible source: IR, DLP-Link
- Depending on the type of synchronization used,
connect the ActivHub
TM
The ActivHub can transmit RF synchronization when
TM
receiving an IR 3D signal.
3D Content
Movie, sports...
The ActivHub can transmit RF synchronization when
TM
connected to a VESA or BNC cable
3D Content
Movie, sports...
The ActivHub can transmit RF synchronization when
TM
receiving a DLP-Link
TM
3D Content
Movie, sports...
8
or VESA
TM
RF as follows :
ActivHUB
RF glasses
In=Wire, Out=RF
ActivHUB
RF glasses
3D signal.
In=DLP, Out=RF
ActivHUB
RF glasses
- The ActivHub RF has several modes of operation (12),
TM
selectable with the wheel. Please select position 8 to use
the EDGE RF properly.
TM
Auto test mode : position 0
Please note that positions 1 and 2 are not meant to be
used in the ActivHub RF50.
TM
- When the configuration is ready, please stand in front
of the screen and press the On / Off button on your
glasses.
- The glasses will automatically search the
synchronization signal.
Once the glasses are synchronized, the LCD lenses will
flash ultra-fast. Then you can watch your 3D content
4. USING YOUR EDGE

4.1 ON/OFF and Auto OFF

ON :
Turn the glasses ON with just a short press of the ON/OFF
button. When switched ON, the lenses will alternately
flash one time (left and right) to indicate to the user that
the glasses are powered ON.
OFF :
Turning the glasses OFF is possible by holding down the
ON/OFF the button.
The glasses will turn off automatically in the following
cases:
- Loss of IR/RF synchronization after 10 minutes.
RF
TM
9