Advertisement
4
Fill the tank using all of the ink in the bottle.
Note:
Refer to the color coded sticker on the ink tank unit cover
to identify the color of each tank.
Caution:
Be sure to fill each tank with the correct ink color.
5
Carefully seal the bottle using the reverse side of the
bottle tip for proper disposal.
6
Replace the ink tank cap securely.
7
Repeat the previous steps for the remaining bottles.
8
Close the ink tank unit cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
10
Turn on the product. Wait for the
flashing, then follow step 11 to continue ink charging.
Note:
If all the product lights are flashing, turn off the product
and check that no protective material has been left inside
the product.
11
Press the
stop button for 3 seconds until the
light starts flashing to begin charging the ink. Ink charging
takes approximately 20 minutes. Ink charging is complete
when the
power light stops flashing.
Note:
The ink bottles included with the printer are designed
for printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
Caution:
Do not turn off the product or load paper while the
product is charging or you'll waste ink.
3
Load paper
1
Make sure the product is not charging ink. Then flip the
feeder guard forward, raise the paper support, and tilt it
backwards slightly.
2
Slide the edge guide to the left.
power light to stop
power
3 seconds
20 minutes
Advertisement
