Sony DVW-970/970P Operation Manual page 138

No. Page
P04 GAMMA
P05 BLACK GAMMA BLACK GAMMA
P06 KNEE
P07 DETAIL 1
138
Menu List
Item Settings
GAMMA OFF/ON
STEP GAMMA 0.35 to 0.90
MASTER GAMMA (–99 to +99)
R GAMMA (–99 to +99)
G GAMMA (–99 to +99)
B GAMMA (–99 to +99)
TEST OUT SELECT ENC/R/G/B
GAMMA SELECT STD/FILM
GAM SEL (STD) 1 to 6
GAM SEL (FILM) 1 to 5
OFF/ON
BLACK GAM RANGE LOW/L.MID/
H.MID/HIGH
MASTER BLK (–99 to +99)
GAMMA
R BLACK GAMMA (–99 to +99)
G BLACK GAMMA (–99 to +99)
B BLACK GAMMA (–99 to +99)
TEST OUT SELECT ENC/R/G/B
KNEE OFF/ON
KNEE POINT 50 to 109%
KNEE SLOPE (–99 to +99)
KNEE SATURATION OFF/ON
KNEE SAT LEVEL (–99 to +99)
WHITE CLIP OFF/ON
WHITE CLIP LEVEL 100.0 to 109.5% 109.0
DETAIL OFF/ON
APERTURE OFF/ON
DETAIL LEVEL (–99 to +99)
APERTURE LVL (–99 to +99)
DTL H/V RATIO (–99 to +99)
CRISPENING (–99 to +99)
LEVEL DEPEND OFF/ON
LEVEL DEPEND LVL (–99 to +99)
DETAIL FREQUENCY (–99 to +99)
Default Description
ON Turns the gamma correction function on/off.
0.45 Sets the master gamma correction curve in
steps.
0 Sets the master gamma correction curve.
0 Sets the R gamma correction curve.
0 Sets the G gamma correction curve.
0 Sets the B gamma correction curve.
ENC Selects the output signal of TEST OUT
connector.
STD Selects the gamma table.
3 Selects the gamma table of STD.
1 Selects the gamma table of FILM.
OFF Turns the black gamma correction on/off.
HIGH Sets the range affected by black gamma.
0 Adjusts the master black gamma.
0 Sets the correction curve of the R black
gamma.
0 Sets the correction curve of the G black
gamma.
0 Sets the correction curve of the B black
gamma.
ENC Selects the output signal of TEST OUT
connector.
ON Turns the knee correction circuit on/off.
85.0 Sets the knee point level.
0 Set the knee slope level.
ON Turns the knee saturation function on/off.
0 Sets the knee saturation level.
ON Turns the white clipping function on/off.
Adjusts the white clipping level.
(DVW-
970)/
105.0
(DVW-
970P)
ON Sets the detail correction function on/off.
ON Turns the aperture correction function on/off.
0 Sets the general level of the detail signal.
0 Sets the aperture level.
0 Sets the level of the V detail signal.
0 Sets the crispening level.
ON Turns the level depend function on/off.
0 Sets the level of the level depend.
0 Sets the frequency of the H detail signal.