Sony DSR-400K/400PK Operating Instructions Manual page 37

For details on using the wireless microphone system, see
the operating instructions for the microphone and tuner.
To attach a WRR-855
1
Open the cover of the WRR connector.
2
Turn on a WRR-855, and set the MUTING to ON or
OFF.
The power of a WRR-855 can be synchronized with
the POWER switch of the camcorder.
3
Insert the WRR-855 into the CA-WR855.
Fasten the screws (supplied with
the WRR-855).
4
Fit the attachment plate on the rear side of the CA-
WR855 to the V-groove on the battery attachment
interface, and then slide the CA-WR855 down until it
connects to the WRR connector.
5
Set one of the AUDIO IN (CH-1/CH-2) switches to
WRR (wireless).
WRR connector
CA-WR855
To attach a WRR-861/862 (When using a
BP-GL65/GL95/L60S Battery Pack)
1
Attach a WRR tuner fitting (not supplied, service part
number A-8278-057-A) to the back of the camcorder.
1 Use a Phillips type screwdriver to tighten the four
screws placed in the tuner fitting as illustrated below.
Note
Make sure that the four screws are fully tightened.
2 Loosen the adjustment screws of the tuner fitting.
3 Adjust the tuner fitting position for a BP-GL65/
GL95/L60S Battery Pack to be attached, and
tighten the adjustment screws to fix its position.
4 Attach the mount plate supplied with the WRR-
861/862.
BP-GL65/GL95/L60S
Adjustment
screws
Back of the
camcorder
2
Attach the battery pack.
For details about attaching the battery pack, see
"Using a battery pack" on page 30.
3
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting (service part
number A-8278-057-A), contact your Sony service
representatives.
Mount plate (supplied
with WRR-861/862)
Phillips type screwdriver
WRR-861/862
Preparing Audio Input System
37