Page 2
Inc. The information contained herein is subject to change without notice. Arista Networks and the Arista logo are trademarks of Arista Networks, Inc in the United States and other countries. Other product or service names may be trademarks or service marks of...
Chapter 2. Package Content..............................4 Chapter 3. O-105 Overview................................ 5 Bottom Panel of O-105................................5 Side Panel of O-105................................6 Chapter 4. Install the O-105..............................8 Mount the O-105..................................8 Pole Mount the O-105..............................8 Wall Mount the O-105..............................9 Power On the O-105................................11 Connect the O-105 to the Network..........................11...
Installation constitutes your acceptance of the terms and conditions of the EULA. Intended Audience This guide can be referred to by anyone who wants to install and configure the O-105 outdoor access point. Document Overview This guide contains the following chapters: •...
Chapter 2. Package Content Please ensure that the items shown in Figure 1-1 are included in the O-105 device package: Figure 1: O-105 Mounting Accessories Important: The MAC address of the device is printed on a label at the bottom of the product and the packaging box.
Bottom Panel of O-105 The bottom panel of the O-105 has LAN/PoE connectors that enable you to connect the device to a wired LAN through a switch or a hub. The ports provide power for the device by using the 802.3at standard.
This port also provides the power for the device using the 802.3at standard Reset Enables you to reset the O-105 Side Panel of O-105 The side panel of the O-105 has LEDs that indicate the working of the device.
Page 8
| 3 - O-105 Overview | 7 Figure 3: O-105 Side Panel The following table indicates the device states based on the LEDs Table 1: O-105 LED Status Description Status Description Power(PWR) Solid Green Power ON Power OFF 5 GHz...
Configuration Guide on our website. Take a configured O-105, that is, ensure that a static IP is assigned to the device or the settings have been changed for DHCP. Note the MAC address and the IP address of the device is in a safe place before it is installed in a hard-to-reach location. The MAC address of the device is printed on a label at the bottom of the product.
3. Mount the device securely to the pole by using the pole strap. Wall Mount the O-105 Use the pole-mount bracket and pole strap to install the O-105 device on a pole. The proposal only supports pole mounting. Standard accessories include two metal clamps.
Page 11
| 4 - Install the O-105 | 10 3. Mount the device on the expansion bolts.
6. Connect the other end of the network interface cable to an Ethernet jack on the desired subnet. 7. Log on to the server through SSH and run the get sensor list command. You would see a list of all Arista devices that are recognized by the server.
Refer to the event for recommended action. The AP has encountered a problem. If you are using Arista Cloud Services, then open the TCP port 443 (SSL). If you have an on-premises installation, then open the ports UDP 3851 and port 80.
Chapter 6. Appendix A: AP-Server Mutual Authentication The AP-server communication begins with a mutual authentication step in which the AP and server authenticate each other using a shared secret. The AP-server communication takes place only if this authentication succeeds. After the authentication succeeds, a session key is generated. All communication between the AP and server from this point on is encrypted using the session key.
Need help?
Do you have a question about the O-105 and is the answer not in the manual?
Questions and answers