Anodes For Prevention Of Galvanic Corrosion; Component Maintenance; Cushions And Hook-And-Loop Fasteners - Ockelbo B18 Series Owner's Manual

NOTE
Type of antifouling paint allowed may vary by region and country, always check local
regulations.

6.2.3 Anodes for prevention of galvanic corrosion

One of the most important maintenance tasks when owning a boat is making sure you
protect the hull and engine from electrolytic corrosion. This can otherwise quickly
create serious damages. Ockelbo boats are therefore equipped with sacrificial anodes,
made from zinc, which are designed to corrode instead of the boat and the engine. They
are mounted at the bottom recess (see chapter 7, figure 1, position 19).
The anodes must be inspected annually and renewed if more than 50% are wasted. It is
important to inspect the working surface of the sacrificial anode to ensure that it is free
of paint and chalky corrosion deposits and particularly very important on the contact
surface between the anode and the hull.
Your engine is likely also equipped with anodes that need to be maintained, see engine
manual for further details.
6.3 C
OMPONENT MAINTENANCE

6.3.1 Cushions and hook-and-loop fasteners

Saltwater, salt residue, dirt, ultra-violet rays etc. will take their toll on vinyl and nylon
products causing them to lose their luster and texture. To clean, remove ordinary dirt
and smudges with a mild soap and water solution. Rinse cleaned area with fresh water
and dry with a clean, soft, lint-free cloth or towel.
Your cushions are not waterproof. They are constructed of open-cell foam and will
absorb and hold water. Do not leave the cushions in standing water or exposed to
heavy, prolonged rain. If, in the event your cushions become waterlogged, remove the
foam from the cushion, press as much water as you can from the foam and allow to air
dry. To prevent mildew, keep the vinyl dry and make sure that moisture does not
6. MAINTENANCE
__PAGE 44