Navigation Lights; Bilge Pump - Ockelbo B18 Series Owner's Manual

4.3 N
AVIGATION LIGHTS
Your boat comes equipped with navigation lighting for use at night or in low visibility
conditions. The use of navigation lights at low visibility conditions is mandatory in most
countries and waters and is always important for your own, as well as others, safety at
sea. Local regulations may vary.
The navigation light switch is located at dash switch panel.
To turn on the Navigation Lights, press "Navigation light" button (see chapter 7, figure 3,
position 5). This illuminates the port (red), starboard (green) and all-around/anchor light
(white) showing other vessels that you are underway. To turn off the Navigation Light,
press "Navigation light" button again.
Prior to running at night, make sure that all navigation lights are working well.
3
1. 112.5⁰ Portside lantern, red
2. 112.5⁰ Starboard lantern, green
3. 360⁰ Top/anchor lantern, white
For complete instructions on maintenance, we refer to the separate OEM owner's manual
that was developed specifically for this equipment. It is provided with the Ockelbo
document bag.
4.4 B
ILGE PUMP
Your vessel is equipped with an electrical bilge pump with automatic and manual switch.
The pump is in the bilge near the transom. Access to the bilge pump is via the motor
well access plate. The pump is rated for 2271 liters/hour and is activated automatically by
free float switch when water in the bilge reaches a predetermined level. In normal
conditions there shall not be any water in the bilge. If there is water, it is caused by leaks
from above (deck, fitting, inspection covers) or damage to the hull (seawater leaks). The
4. SYSTEMS & COMPONENTS
1
__PAGE 33
2