Maintenance And Cleaning; End Of Programme; Cleaning The Detergent Drawer; Cleaning The Loading Door And The Drum - Beko HITY 854310F User Manual

Table of Contents

Advertisement

Available languages

Available languages

5.20 End of programme

When the programme is over the End of
Programme indicator illuminates and a buzzer is
heard.
If you do not press any button for 2 minutes, the
machine will switch to standby mode. Display
and all indicators are turned off.
If you press any button or turn the Programme
Selection knob when the machine is in standby
mode, programme steps that are completed will
appear on the display.
5.21 Your machine features
a "Standby Mode".
After you switch on your machine with On-Off
button, if no programme is started or no other
procedure is performed at the selection step or
no action is taken within approx. 2 minutes after
the selected programme ends, your machine
will switch to energy saving mode automatically.
Also, if your product has a display that shows
programme time, this display will be completely
turned off. If you turn the Programme Selection
knob or touch any button, lights and display
will switch back to previous condition. The
selections which you make when exiting from
the energy efficiency may change. Please check
the correctness of your selections before starting
the programme. If necessary, please make your
settings again. This is not an error.
30 / EN

6 Maintenance and cleaning

Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.

6.1 Cleaning the detergent drawer

Remove any powder residue buildup in the
drawer. To do this;
II
II
I
1. You can remove the detergent drawer by
pulling it towards yourself strongly.
C
INFORMATION
• If more than a normal amount of softener
and liquid detergent mixture starts to
remain in the softener compartment,
the siphon must be cleaned.
2. Wash the drawer and the siphon with plenty
of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush
to avoid touching the residues in the drawer
when cleaning.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
6.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
For products without drum cleaning programme,
follow the below steps to clean the drum:
Washer-Dryer / User's Manual

Advertisement

Table of Contents
loading

Table of Contents