Adjusting The Feet; Electrical Connection; Transportation Of The Product - Beko HITY 854310F User Manual

3.6 Adjusting the feet

A
CAUTION!
• Adjust feet so that the product will be
balanced in the location it will be used.
• Balance the machine by adjusting the feet.
• Check for any play by pressing the
product from upper diagonal edges.
• Otherwise, the product may move
from its place and cause crushing,
noise and vibration problems.
• Do not use any tools to loosen
the lock nuts. Otherwise, the
lock nuts may get damaged.
a) Loosen the lock nuts on the feet by hand.
b) Adjust the feet until the product stands level
and balanced.
c) Tighten all lock nuts again by hand.
Adjusting Rear Feet
• When you turn the knob (visible in the circle) in
the direction of the arrow, the machine will be
elevated by 0.3 mm. When you turn it in the
opposite direction of the arrow, the machine
will be lowered by 0.3 mm.
• Do not adjust the rear feet by using chargeable
devices. Use a screwdriver instead.

3.7 Electrical connection

Connect the product to a grounded outlet
protected by a 16 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national regulations.
12 / EN
• The wiring for the electrical outlet circuit
must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit
Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
B
DANGER!
• Damaged power cables must be replaced
by the Authorised Service Agent.

3.8 Transportation of the product

1 Unplug the product before transporting it.
2 Remove water drain and water supply connections.
3 Drain all water that has remained in the
product. See 6.5
4 Install the transit bolts in reverse order of the
disassembly procedure. See 3.3
B
DANGER!
• Your product is too heavy for
one person to carry.
• Your product is heavy; two persons
must carry it and extra precaution
taken on stairs. If your product falls
on you, it may cause injuries.
A
CAUTION!
• Packaging materials are dangerous to
children. Keep packaging materials in a
safe place away from reach of the children.
C
INFORMATION
• Never move the product without the
transit bolts properly fixed in place!
Washer-Dryer / User's Manual