Charging Time - Sony Handycam DCR-SR47E Handbook

Charging time

Approximate time (min.) required when you fully charge a fully discharged battery pack.
DCR-SR37E/SR38E/SR47E/SR48E/SR57E/SR67E
Battery pack
NP-FH30 (supplied)
NP-FH50
NP-FH70
NP-FH100
DCR-SR77E/SR87E
Battery pack
NP-FH50 (supplied)
NP-FH70
NP-FH100
When the battery pack is charged at 25

To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever  and remove the battery pack
.
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack. " Even if the battery pack is
attached, the battery pack is not discharged.
Charging the battery pack abroad
You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Do not use an electronic voltage transformer.

Notes on the battery pack
When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure

that the (Movie) lamp/
off.
The CHG (charge) lamp flashes during charging under the following conditions:

The battery pack is not attached correctly.

The battery pack is damaged.

In the default setting, the power turns off automatically if you leave your camcorder without any

operation for about 5 minutes, to save battery power ([A.SHUT OFF]).
Charging time
115
135
170
390
Charging time
135
170
390
C (77 ˚F) (10

(Photo) lamp (p. 19)/ACCESS lamp (p. 16)/access lamp (p. 60) are turned
17
C to 30 C (50 ˚F to 86 ˚F) is recommended)
 