Safewatch Pro 3000 System Manual
If you make a mistake while entering your security code, first stop and then press [*][*] to start
over.
There are four possible modes for arming your system:
1. Instant Mode arms the entire perimeter when no one is expected to use an entry/exit door. The
alarm will sound immediately if any protected zone is opened, including designated entry/exit doors. Exit
delay is not possible in instant mode. To activate, press your [security code] + [7].
2. Stay Mode arms the entire perimeter and an alarm will sound if any protected area or non-entry/exit if
opened. Stay mode triggers the exit delay; setting the stay mode does not arm the system immediately
but rather after a designated amount of time (referred to as the exit delay). To activate, enter [security
code] + [3]
3. Night-Stay Mode arms the entire perimeter in addition to pre-selected interior sensors. In this mode,
alarms will sound if interior zones are triggered (e.g., entering area in the middle of the night), though
entry/exit is possible through designated areas. To activate, enter [security code] + [3] + [3].
4. Away Mode arms the entire interior and exterior. As such, this mode is not ideal for those with
pets/children roaming in and out of interior zones. Away mode triggers the exit delay; setting the away
mode does not arm the system immediately but rather after a designated amount of time (referred to as
the exit delay). You may reenter through the designated entry/exit door without causing an alarm, but
you must disarm the system within the entry delay period. To activate, enter [security code] + [2].
Disarming
PLEASE NOTE: If your alarm is sounding upon return, DO NOT ENTER! CALL THE POLICE from a safe
location. If you return and find that the main sounder has shut itself off but the touchpad is beeping
rapidly, TAKE CAUTION Your alarm was activated while you were out.
Your security code + OFF is used to disarm the system, to silence the alarm and trouble sounds, and to
clear any alarm memories. The touchpad will emit a single tone to confirm that the system has been
disarmed and/or silenced.
To clear the memory of an alarm, press your security code + OFF key first, then enter your security code +
OFF again to clear.
Bypassing Protection Zones
Zones (also called partitions) are areas that can be bypassed when arming the system. This could be ideal
for those who want to arm all but one door/window.
Bypassing Protection Zones
https://alpha.adt.com/help/63[11/12/2018 9:41:21 PM]
Need help?
Do you have a question about the Safewatch Pro 3000 and is the answer not in the manual?