Fitting Supplied Wall Spacers; Limiting The Opening Angle Of The Appliance Door; Fitting The Door Opening Angle Limiter - Miele KFN 29683 D obsw Operating And Installation Instructions

Fitting supplied wall spacers

The wall spacers supplied must be
used in order to achieve declared
energy consumption values and to
prevent the build-up of condensation
at high ambient temperatures. The
appliance depth is increased by
approx. 15 mm with the wall spacers
fitted. If the wall spacers are not used,
the functionality of the appliance is not
affected. Energy consumption is only
slightly increased with less distance
between the appliance and the wall.
 Fit the wall spacers onto the back of
the refrigeration appliance on the
bottom left and right.
Limiting the opening angle of
the appliance door
The door hinges are set ex works to
enable the door to be opened up to
115°. If the appliance door hits an
adjacent wall when opened, for
example, the opening angle can be
limited to approx. 90°:
The door opening angle limiter should
be fitted before the refrigeration
appliance is installed.

Fitting the door opening angle limiter

 Switch off at the wall and remove the
plug from the socket, or disconnect
the mains fuse.
– Removing the soft-close
mechanism
 Open the appliance door.
 Push off right outer cover .
Installation
89