Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Pump Section (cont.)
ASSEMBLING
(8) Assemble Refueling winding to Refueling handle group as drawn in Fig. 12.
Fig. 12
1. Align the hole for Stopper of Refueling winding
to the curve of
Refueling handle
2. Insert Stopper of Refueling winding
into the hole along the curve.
5. Guide the other end of Refueling
winding to Carburetor side by passing
it under Pump frame.
(9) Assemble Refueling winding to Throttle lever of Carburetor as drawn in Fig. 13.
Fig. 13
1. Connect the other end of Refueling winding to Carburetor. Then align the lever of
Refueling handle group
Carburetor is contacted to
If the screw is not connected to the lever, regulate Adjust screw until Adjusting screw
of Carburetor contacts
2. Assemble Air cleaner cover with M5x14 Pan head screw.
group.
Curve
Groove
Sheath
Pump frame
to "L" position. And then make sure that Adjusting screw of
Throttle lever of
Carburetor.
Throttle lever of
Carburetor.
Adjust screw
Stopper
Refueling handle group
3. Put the inner cable of Refueling winding
into the groove of
Refueling handle
4. Connect the sheath of Refueling winding
to the original position of Refueling handle
group.
Adjusting screw of Carburetor comes
in contact with Throttle lever of
Carburetor at "L" position of
Refueling handle group.
Air cleaner cover
P 9/ 10
group.
Advertisement
