Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Pump Section (cont.)
ASSEMBLING
(7) Assemble Shelf group as drawn in Fig. 11,
and check the condition of Impeller, in case of replacing the Engine to the new one.
Fig. 11
1. Assemble Shelf group to the machine
with M8x35 Hex bolt, Flat washer
Wave washer and
M8 Hex nuts.
Wads
(Wave washers)
M8 Hex nuts
1. Make sure that the fuel is removed completely from the Engine.
2. Switch off.
3. Pull Recoil starter in order to make sure that the rotating Impeller does not touch Volute.
In case of touching Volute, return to Fig. 8, and adjust by adding or reducing Washer(s).
Flat gaskets
(Flat washers)
In case of replacing the Engine to the new one
2. Tighten M8x35 Hex bolt and M8 Hex nut
to 13 N.m fastening torque.
M8x35
Hex bolts
Shelf group
P 8/ 10
Advertisement
