System Configuration Screen Options - Dell OptiPlex 7760 Setup And Specifications Manual

Option Description
•
Advanced Boot This option allows you the legacy option ROMs to load. By default, the Enable Legacy Option ROMs is disabled.
Options
•
•
•
•
Date/Time Allows you to change the date and time.

System configuration screen options

Option Description
Integrated NIC
If you enable UEFI network stack, UEFI network protocols will be available. UEFI network allows pre-os and early os
networking features to use NICs that are enabled. This may be used without PXE turned on. When you enable
Enabled w/PXE, the type of PXE boot (Legacy PXE or UEFI PXE) depends on the current boot mode and type of
option ROMs in use. The UEFI Network Stack is required in order to have UEFI PXE functionality fully enabled.
•
Allows you to configure the integrated network controller. The options are:
•
•
•
•
SATA Operation Allows you to configure the internal SATA hard-drive controller. The options are:
•
•
•
Drives Allows you to configure the SATA drives on board. All drives are enabled by default. The options are:
•
•
•
•
SMART Reporting This field controls whether hard drive errors for integrated drives are reported during system startup. This
technology is part of the SMART (Self Monitoring Analysis and Reporting Technology) specification. This option is
disabled by default.
•
USB Configuration This field configures the integrated USB controller. If Boot Support is enabled, the system is allowed to boot any
type of USB Mass Storage Devices (HDD, memory key, floppy).
Never
Restore Settings - Restores the default settings of the computer
Save Settings - Saves the settings of the computer
Apply - Enables you to apply the settings
Exit - Exits and starts the computer
Enabled UEFI Network Stack - This option is disabled by default.
Disabled
Enabled
Enabled w/PXE: This option is enabled by default.
Enabled w/Cloud Desktop
NOTE: Depending on the computer and its installed devices, the items listed in this section may or may
not appear.
Disabled
AHCI
RAID On: This option is enabled by default.
SATA-0
SATA-1
SATA-4
M.2 PCIe SSD-0
Enable SMART Reporting
System setup 27