Ordering Of Spare Parts; Trouble Shooting - Farmi Forest Corporation JL 601 Operating, Maintenance And Spare Parts Manual

www.normet.fi
JL 601
MAINTENANCE, LUBRICATION AND
ADJUSTMENT INSTRUCTIONS

12. TROUBLE SHOOTING

CONDITION
Hard to pull the cable out
Cable gets tangled on the
drum
Cable develops kinks
Roller chain comes off
Rattling sound
Insufficient pull on the cable
Front end of tractor comes off
ground when winching.
Tractor slides backwards when
winching
Normet Corporation
Ahmolantie 6
FIN --- 74510 PELTOSALMI
FINLAND
Tel. + 358 (0) 17 83 241
Fax. + 358 (0) 17 823 606
POSSIBLE CAUSE
Drum brake is too tight
Cable too loose on the drum.
The cable is pressed between
loose loops.
Cable brake too loose
Roller chain too loose, some
part is broken or the aligning is
incorrect.
Roller chain too tight, some
part is broken or the aligning is
incorrect.
Normal wear of the clutch. Mini-
mum thickness of the clutch
plates is 7mm
Oil or grease in the clutch
Tractor too light in front
Parking brakes are not on.
Dozer blade does not anchor
the unit firmly to the ground.
B // En // 141001MRu
REMEDY
Loosen the drum brake. See
instructionsfrom item 10.3
"Adjusting the drum brake".
Loosen the pin and pull the
cable from the reel with the
help of a tractor. Reel the cable
tightly back in with the help of
the load
Tighten the drum brake.Tighten
cable on the drum by pulling
out the cable and by winching
with a heavy load.
Check the aligment of the
chain. Check possible dam-
ages. Adjust the roller chain,
change if necessary. See chap-
ter 10.2 "Adjusting the roller
chain".
Check the aligment of the
chain. Check possible dama-
ges. Adjust the roller chain,
change if necessary. See chap-
ter 10.2 "Adjusting the roller
chain".
See chapter 10.1 "Clutch
adjustment".
Disassemble and clean the
parts
Add front end weights
Lock on the parking brakes
Lower the winch all way to the
ground.
Page 21