Safety; Lubrication; Service; Clutch Adjustment - Farmi Forest Corporation JL 601 Operating, Maintenance And Spare Parts Manual

www.normet.fi
JL 601
MAINTENANCE, LUBRICATION AND
ADJUSTMENT INSTRUCTIONS

8. SAFETY

Disengage the P.T.O and turn
the tractor off before you
service the winch, remove the
keys so the tractor cannot be
DANGER!
started up accidentally.

9. LUBRICATION

Do not oil the drive chain,
because the oil will work its
way to the clutch!
NOTE!
The cable drum, main sprocket and
snatchblock are fitted with self lubricating
bearings.
Following points require lubrication:
1. Grease the drum clutch parts after every
500 working hours. Always use good
quality lubrication grease.
2. Grease the PTO---shaft regularly and
aways before use as shown in figure 31.
3. Grease the drum chain lightly (not with oil)
after every 50 working hours with spray type
, hardening chain grease. Wipe off the
excessive grease.
Swing joints sideways for greasing
8h
When used in winter the
guard tubes must be grea-
sed to avoid freezing.
Fig. 31. P .T .O shaft lubrication.
Normet Corporation
Ahmolantie 6
FIN --- 74510 PELTOSALMI
FINLAND
Tel. + 358 (0) 17 83 241
Fax. + 358 (0) 17 823 606
8h
20h
Apply grease inside the
outer telescopic profile
h= working hours

10. SERVICE

10.1. CLUTCH ADJUSTMENT

1. Loosen the nuts A and B at both ends of
the drum axle. Wrench opening 1
mm).
2. Adjust the clutch by turning the axle C with
9
/ " or 14 mm wrench. The clutch
16
tightens clockwise, loosens
counterclockwise. Turn max. 1/4 turn.
3. After adjustment retighten the nuts A and
B on the ends of the drum axle.
4. Pull the control rope. The lever should
move up 1.5" (4cm) before the clutch
engages. If the clutch engages earlier
loosen the clutch setting.
A
Fig. 32. Clutch adjustment.
B // En // 141001MRu
7
/ " (36
16
B C
Page 18