Reassembling The Winch Mechanism; Fin --- 74510 Peltosalmi - Farmi Forest Corporation JL 601 Operating, Maintenance And Spare Parts Manual

www.normet.fi
JL 601
MAINTENANCE, LUBRICATION AND
ADJUSTMENT INSTRUCTIONS
10.5. ASSEMBLY OF THE MECHANISM
Make sure that the both pressure bearings are
installed in a correct position, that is, the
bearing with bigger internal diameter should be
facing the cable drum (figure 37). Make sure
that the position of the two clutch engagement
halves is correct:
1. Place one of the clutch engagement
halves on the working tble so that the
handle is at 8 o'clock position and the 3
slanted surfaces face up. See fig.36.
2. Grease the 3 slanted surfaces with
vaseline and place the 3 rollers on the
bottom of the slanted surfaces so that the
thin ends point towards the middle.
The other clutch engagement half (without
handle) has 3 slanted surfaces on one side
and two holes drilled on the other side (fig 36).
Two studs on the back of the front plate will fit
into these holes later on when the winch is
assembled.
3. Place one clutch engagement half (without
the handle) so that the halves bottom out
when the handle is at 8 o'clock position
and the two holes are at 12 o'clock and 6
o'clock (fig. 36). Be careful, there is only
Race with smaller inside diameter
Race with larger inside diameter
Fig. 37. Correct positioning of the thrust bearings.
11. ORDER SPARE PARTS
When ordering spare parts, please refer to your machines type code on the name plate and to the
spare parts lists order number, description and quantity desired.
JL 601, 54511340, Bearing, 1 pc.
Normet Corporation
Ahmolantie 6

FIN --- 74510 PELTOSALMI

FINLAND
Tel. + 358 (0) 17 83 241
Fax. + 358 (0) 17 823 606
The race with the larger
inside diameter is towards
the drum
one correct position! Tape the halves
together so that htey will stay together
when you mount them on the drum axle.
Install a protective plate. Check the clutch
adjustment.
12
8
6
12
6
12
8
6
Fig. 36. Reassembling of the clutch
engagement halves.
Drum
Drum axle
The race with the larger
inside diameter is towards
the drum
B // En // 141001MRu
a)
b)
c)
Page 20