Vancare Vera-Lift V350 Operating Manual page 17

(The height of the foot pad can be raised by positioning it on the upper mast pegs for
VERA-LIFT™ models without scales.)
Lock the caster brakes.
10.
11. Connect the back belt to the lift arm hooks snuggly:
a. Cross one back belt white strap through the loop closest to the back belt on
the other white strap.
b. Connect the right side white back belt loops to the left lift arm hook and
connect the left side white back belt loops to the right lift arm hook using the
same loop on both sides of the back belt.
c. Remove the colored straps from the VELCRO pocket under the patient's arms
and connect the colored straps straight (not crossed) to the lift arm hooks
using the same loop on both sides of the back belt. (The upper or lower lift
arm hooks may be used for short to medium height patients. The upper hooks
should be used for tall patients as this will help the patient to stand erect on
the VERA-LIFT™.)
12. Snuggly fasten the knee strap behind the patient's knees.
Double check the back belt loop connection to the lift arm hooks to make
13.
sure the loops are connected securely to the lift.
14. Lift the patient to a standing position.
15. Unlock the VERA-LIFT™ brakes and back the lift away.
16. While slowly turning the lift, move the patient to the desired location
within the room with the back of the patient's legs against the bed,
wheelchair, etc.
17. Leaving the caster brakes unlocked, lower the patient so that his or her buttocks are
positioned correctly on the bed or at the back of the wheelchair seat, etc.
18. Remove the back belt from the lift arm hooks, unfasten the knee strap and back the
lift away from the patient.
19. Unclip the buttock support strap and unfasten the inner safety belt. Remove the
back belt.
20. Make sure the patient is safely positioned before removing the VERA-LIFT™ and back
belt from the room.
April 2013 For your nearest Distributor, call 1-800-694-4525
November 2017 For your nearest distributor, call 1-800-694-4525
16
16