IBM 3274 51C Maintenance Information page 78

019
Map A150, Installation/
Customization Problems
PAGE 5 OF 7
o
See figures in the initial customizing procedure of the
Planning, Set-Up and Customizing Guide and look up 8421
indicator code. Verify that the correct meaning / action fix
was performed.
o
Verify that the configuration information was correctly
entered. Perform the modification procedure of the Planning
and Set- Up Guide for displaying the configuration
information and verify against 3274 customizing procedure
form. See *S*
o
If an uncustomized system diskette is being customized the
following cards in the A 1 board can be loose or defective:
No. 10,22, 1,2,3,4,5,6. See *E*.
o
Obtain another feature diskette and perform customization
once more.
o
Use your support structure for aid if problem is not
corrected.
020
o
Follow the initial customized procedure, replacing the feature
diskette with the system or language or RPQ diskette.
When performing procedures without feature diskette, did the
8421 indicators display the proper code/codes? ·C*
Y N
021
o
See figures in the initial customized procedure of the
Planning and Set-Up Guide and look up the 8421 indicator
code. Verify that the correct meaning / action fix was
performed.
o
If an 'uncustomized system' diskette is being customized the
following cards in the A 1 board can be loose or defective:
No.1, 2, 3, 4, 5, 6. See *E*
o
Obtain another system diskette and perform customization
once more.
o
Use your support structure for aid if problem is not
corrected.
022
o
Perform an IML startup.
Go to Page 6, Step 024, Entry Point C.
MAP A150-5
*E*
These cards either were not tested when the 'uncustomized'
system diskette was run or can cause customizing problems. The
cards can only be tested after a successful customization when an
IML startup is performed. At this time a diagnostic test will test
these cards.
Chapter 3. Maintenance Analysis Procedures 3-51