How To Use Remote Controller; Dlp Panel Control - HDL -MTIRW Manual

HDL
®
The remote controller's Icon can be changed via HDL Easy Engineering
Editor.

3. How to use Remote Controller

3.1 DLP panel control

Fig.7 DLP panel interface
Fig.8 HVAC interface
Fig.9 Z-audio interface
MTIRW IR/RF Remote Controller
DLP panel control
1) Press the button
2) Press the button
3) Remote controller's button, those No.1 to
No.8 buttons of Rmote controller can control corresponding
buttons in wall panels
4) If the button's mode is sing on/off, the target is single
channel lighting, long press the button increase or decrease
the brightness
Air-condition control：
Button 1/2：HVAC ON/OFF
Ø
Button3/4：reduce/increase temperature
Ø
Button 5/6：change fan speed
Ø
Button7/8：change mode
Ø
Music control：
Button 1/2：set sound source/ON or stop
Ø
Button3/4：select previous/next play list
Ø
Button 5/6：select previous/ next song
Ø
Button7/8：reduce/increase sound
Ø
press button 1 for 2 seconds，DLP panel will enter into the page
of set parameters.
Button 1/2: infirm button, when you are change parameter
Ø
you must control these buttons.
Button3/4:change parameter
Ø
Button 5/6:change parameter
Ø
Button7/8: exit, back to the previous page
Ø
5
or for select the DLP panel.
or , change DLP panel's page