Wireless Address Setting; Firmware Upgrade; Universal Code - HDL -MTIRW Manual

HDL
®

2.3 Wireless address setting

Each wireless remote controller has an address, the address range is
1~65534.
You can set up to four "receiving address" in each wireless receiver,
correspondingly, so the wireless receiver can receive control
commands from maximum four matched wifi remote controllers.
Fig.4 wifi remote controller's address setting
Fig.5 wireless receiver's address setting

2.4 Firmware Upgrade

When upgrading firmware, you need connect USB to PC. Double click
to open Mobile devices "CRP DISABLD" in "my computer", then use
the new ".Bin" file to replace existed "firmware.bin" . after that, reset
the Remote controller to make your upgrading effective

2.5 Universal code

The remote controller has been fixed infrared codes about HDL all
panels, don't need to learn.
"DLP panel" page can't control other panel except DLP panel.
we can use the "1 row panel" page of IR&RF controller to control 1 Row
panels, 2 Row panels, touch panels and even LCD DLP panels, and
those IR codes we call it Universal codes
MTIRW IR/RF Remote Controller
Wife remote controller's address
Fig. 6 Upgrade firmware
4