Advertisement
Eaton's Wiring Devices
Home automation hub
To connect your Home automation hub using
WiFi:
1. Download the Eaton Home App. If you are
using the app for the first time, create your login
using your email, google account or your
facebook account.
2. Ensure that the HOMECT is powered on, and
then connect your Android or iOS device to the
Eaton WiFi (EatonWifi-XXXX).
Note: XXXX represents the last characters 4 of the
units MAC address.
3. Open the Eaton Home App, and then wait for
network dialog to display.
4. Enter your home's WiFi SSID and password as
prompted, and then tap Next.
Note: The SSID is case sensitive.
5. Follow the displayed instructions.
6. Wait for the LED to become solid blue, this can
take up to 90 seconds.
Note: If the LED does not change solid blue, see
Troubleshooting on page 4.
7 . Reconnect your Android or iOS device to your
home's WiFi, and then re-open the Eaton
Home App.
8. Tap the Inventory icon
Settings icon
.
9. The Locations dialog displays. Select the project
-- No project --. See Figure 4.
10. Tap outside of the Locations dialog box, and then
enter the PIN 1234 as prompted.
You are now ready to configure the project.
Figure 4: Eaton Home project display
Configure, test, and deploy a project
Refer to the following instructions on creating,
testing, and deploying devices. You can deploy the
devices through your Eaton Home app.
Including Z-Wave device to Home Automation
Hub:
For the Eaton Home mobile application, follow the
following steps:
• Tap the Inventory icon
• Select 'Devices' from the 'Configure' menu at
the bottom of the screen
• Tap the Inventory icon
the screen
• Select the category of device you want to add to
the controller. E.g.: 'Lighting'
• Name the device you want to add and select the
area you want. Tap 'Continue'
• Tap 'Start Discovery Mode' to put the device in
• Follow the instructions with your Z-Wave device
• Once the device has been included, the app will allow
Excluding Z-Wave device to Home Automation Hub:
For the Eaton Home mobile application, follow the
following steps:
• Tap the Inventory icon
• Select 'Devices' from the 'Configure' menu at the
• Select the category of device you want to exclude
• Tap '⋮' next to the name of the device you want to
• Tap 'Start Removal Mode' to put the controller in
• Follow the instructions with your Z-Wave device to put
, and then tap the
• Follow the instructions on the screen to compete the
Mounting the Home automation hub on a standard
single gang box
1. Place the wall mount against a standard gang box. See
2. Align the long screws in the wall mount, and then
3. Align the Home automation hub over the screws, and
Figure 5: Home automation hub wall mounting
on the top right
from the bottom of
(1)
(2)
(3)
inclusion mode.
to put that device in pairing mode. Follow the
instructions on the screen to compete the inclusion
process.
you to configure the device settings. You can tap '<'
icon to exit to the main screen.
bottom of the screen
from the network; the screen should show list of all
the devices in that category.
exclude. Tap 'Remove' from the drop down menu
exclusion mode.
that device in exclusion mode.
exclusion process.
Figure 5, items 1 and 3.
fully screw them in. Repeat this with the short screws,
stopping with enough room remaining to support the
Home automation hub. See Figure 5, items 4 and 5.
then slide it down, locking it in place. See Figure 5,
item 6.
Gang box
Wall
Wall mount
on the top right
Short screws
(4)
(5)
Long screws
Home automation hub
(6)
Advertisement
