Eaton HOMECT Installation And Setup Manual

Eaton's Wiring Devices
Home automation hub
Home automation hub installation and setup guide
Description
The Eaton Home Automation Hub (HOMECT)
provides all device management services, supports
Eaton Home user interface services, and acts as the
gateway to the Cloud for system updates. The hub
comes complete with the EatonOS pre loaded. The
controller also comes equipped with a Z-Wave
(908.4 MHz) transceiver for controlling your other
devices, such as integrated lighting, thermostats,
sensors, and locks.
Note: Models are subject to change without notice.
WARNING: Any changes or modifications made
to this product not expressly authorized by the
manufacturer could void the user's right to operate
this device.
Unpacking the Home Automation Hub
Remove all contents from the Hub packaging and
ensure you have the following items.
• 1 × Home automation hub
• 1 × 5v micro USB power supply (p/n 950-5001-0)
• 1 × wall mounting kit (p/n 950-5002-0)
o 1 × wall mounting bracket (p/n 200-1838-0)
o 2 × long screws (8-32 × 5/16")
o 2 × short screws (6-32 × 3/4")
• 1 × paper clip (p/n 950-5003-0)
• 1 × Quick Start Guide
• 5 × UUID/Mac identification labels
WARNING: Do not apply power to the HOMECT
until installation is complete. Failure to do so
may result in bodily injury and/or damage to the
equipment.
Installation
We recommend placing the Home automation hub
in an open centrally located area within the home,
and using the included wall mount to attach the
Home automation hub to a standard single gang box.
The Home automation hub should not be mounted
in a structured enclosure, panel, or closet. If the
Home automation hub is placed in a closed off area, the
wireless signal strength may be compromised.
Note: To prevent radio frequency (RF) interference, we
recommend that you place the Home automation hub
away from devices that may cause interference and away
from grounded metals.
Figure 1: HOMECT connections
(1) Recessed push button
(2) 2 USB ports
(3) Wire routing channel
(p/n HOMECT)
(p/n 100-1834-0)
(p/n 100-1849-0)
(4) Wall mount slots
(5) Micros USB ports
(6) Ethernet port