Engine Fuel Level - King Canada Power Force KCG-2421GE Instruction Manual

24” 2-stage gasoline snow blower with electric start
Table of Contents

Advertisement

ASSEMBLY
INSTALLING AND ADJUSTING SKID SHOES
1) Loosely install the skid shoes (A) Fig.5 using carriage bolts and hex. nuts (B),
install one on each side of the auger housing as shown. Make sure the skid shoe
tip faces out.
2) Adjustment of the skid shoes sets the height above the ground at which the auger
shave plate operates. For clearing snow from concrete, asphalt, and other
smooth surfaces, set the skid shoes so that the bottom of the plate is just above
the ground. For clearing snow from gravel, dirt, and other rough surfaces set the
skid shoes to slightly raise the shave plate above the ground to avoid dirt and
gravel from entering the auger.
INITIAL SETUP BEFORE OPERATION
ENGINE OIL LEVEL
WARNING! This engine has been shipped from the factory without oil or very
little oil in the crankcase. Operating your engine without the correct amount of
oil can damage it. Oil crankcase capacity: 0.6 litres.
Always check the oil level before starting the engine, make sure the engine is
on a level surface. To check oil level:
1) Turn the oil fill/gauge dipstick (A) Fig.6 counterclockwise, remove it and clean it
with a clean cloth.
2) Fully reinsert the oil gauge dipstick and pull it out to check the oil level.
3) If the oil level is halfway up the dipstick or below, refill with SAE 5W30 oil through
the dipstick hole until the oil level reaches 3/4 up the dipstick or until it reaches the
bottom lip of the dipstick hole as shown in illustration Fig.7.
4) Reposition the oil gauge dipstick and tighten it by turning clockwise.

ENGINE FUEL LEVEL

WARNING! Make sure there is enough fuel in the fuel tank before operating.
1) If it is necessary to add fuel, first make sure the engine switch is OFF, then open
the fuel cap (A) Fig.8 by turning it counterclockwise. Make sure the fuel filter (B)
is installed in the tank opening.
2) When refueling, keep in mind all safety precautions and make sure to add enough
fuel based on usage. Use clean unleaded gasoline with a minimum of 87 octane.
Do not mix oil with gasoline. Fuel tank capacity: 3 litres.
ASSEMBLY & INITIAL SET-UP
BEFORE OPERATION
Figure 5
Figure 6
Figure 7
Figure 8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents