King Canada Power Force KCG-2421GE Instruction Manual page 12

AUGER BELT REMOVAL continued...
3) Loosen the belt guide pin hex. bolt (A) Fig.20 (installed on engine crankcase)
and rotate the guide pin (B) away from the pulley (C) as shown.
4) Left Side - Loosen the 3 nylon hex. nuts (A) Fig.21 attaching the auger housing
to the main frame.
5) Right Side - Remove the hex. nuts (B) Fig.21 attaching the auger housing to the
main frame.
6) Remove the auger belt (A) Fig.22 from the drive pulley (B) while pulling the right
side of the auger housing away from the main frame just enough to access the
auger belt and pulley.
7) Push the auger tension pulley arm (C) to move the auger brake (D) away from
the belt to allow removal of the belt.
8) Remove the auger belt (A).
AUGER BELT INSTALLATION
WARNING! Entanglement Hazard – Before performing any service procedures,
make sure the engine is off and remove the spark plug wire from the spark plug to
ensure the engine cannot accidently start.
1) Push the auger tension pulley arm (C) Fig.22 to move the auger brake (D) to
allow access for installation of the belt into the auger pulley (B).
2) Route the belt to the inside of the tension pulley, auger brake and install the
auger belt onto the drive pulley while pulling the auger housing into position with
the main frame.
3) Install and tighten the nylon hex. nuts (A & B) Fig.21 attaching the auger housing
to the main frame. Tighten all fasteners securely, do not over tighten.
4) With the belt installed on both pulleys and tension pulley in position, move the
belt guide pin (B) Fig.20 to within 3/16" to 3/8" from the belt seated in the pulley
and tighten the pin in position.
Note: The belt guide pin helps keep the belt in the pulley when the belt is
disengaged. The pin should not be tight to the belt. The pin should be loose enough to allow the belt to spin freely but not allow the belt to jump
off the pulley.
5) Reconnect the upper cable (A) Fig.18 to the auger control handle (B).
6) Reinstall the belt cover (A) Fig.19 using 2 hex. bolts (B).
WARNING! Make sure the belt cover is reinstalled and all safety guards are in place before the engine is started and snow blower is operated.
SNOW BLOWER MAINTENANCE
Figure 20
Figure 21
Figure 22