Changing A Lamp - Miele DA 396-7 Operating And Installation Instructions

Cleaning and care

Changing a lamp

The lamps should be replaced with the
following:
Manufacturer ............................... EGLO
Lamp type .................................... GU10
Specification................................. 12981
Wattage ........................................... 3 W
ILCOS D Code...... DR-3-H-GU10-50/56
These lamps are available from Miele or
from specialist retailers.
 Switch off the fan and the lighting.

Note that the lamps become hot
when in use.
They can cause burns even after
being switched off for some time.
Allow the lamps to cool down for a
few minutes before changing them.
 Disconnect the rangehood from the
mains electrical supply before
replacing the lamps (see "Warning
and Safety instructions").
 Remove the grease filters.
 Turn the nut anti-clockwise as far as it
will go. The lamp will then drop down
towards you.
24
 Turn the lamp anti-clockwise and pull
it out.
 Screw the new lamp into the socket
and push it upwards. Please follow
the manufacturer's safety
instructions.