Accessories; Co2 Sensor; Em-Box; Electrical After-Heating Element - nilan CTS602 HMI Installation Instructions Manual

Accessories

CO sensor
2
Fitting a CO
higher ventilation levels in the event of high CO
levels can be programmed.

EM-box

With an EM box it is possible to divide the extract air between the kitchen and the
bathroom.
If a cooker hood is connected to the unit and is switched on, extract air from the
bathroom will be reduced slightly to allow sufficient air for the cooker hood to
extract kitchen fumes.
The EM-box has a fitted metal filter that clears the air in the cooker hood of
grease particles effectively, and thereby protects the unit.

Electrical after-heating element

With an electrical after-heating element you can increase the supply air
temperature to the desired level. Electrical after-heating elements are supplied
for mounting in the supply air duct. Included are the necessary sensors.

Pollen filter

As a standard, the unit is supplied with a plate filter.
If anyone in the household suffers from a pollen allergy, you can install a pollen
filter in the outdoor air intake to minimize the proportion of pollen in the indoor
air.
A pollen filter also removes approx. 50 % of harmful particles in outdoor air, so a
pollen filter is recommended if you live in a large city or close to a motorway.

Water trap

To ensure that condensate water can drain freely, a water trap must be installed.
You should check regularly that there is water in the trap. The water trap may
dry out during late spring, summer and autumn, when no condensation is formed.
If the water trap dries out, air will be sucked into the unit and condensate water
will not be able to drain. This will cause water damage.
Nilan's water trap contains a ball that ensures that no air is sucked into the unit
and that condensate water can drain freely.
sensor means the ventilation speed can be pre-programmed to run
2
Combi 302 Polar Top (English)
level in the extracted air. CO
2
BY NILAN
2
11