Hitachi Compute Rack 220H Replacement Manual page 55

4. Wait about 30 seconds until the disk motor stops. Then, pull out the
HDD/SSD straight forward.
NOTICE
Figure 4-2: Remove a failed HDD/SSD
Installing a HDD
1. Open the HDD tray lever of the replacing HDD/SSD.
2. Insert the HDD/SSD into the extension storage bay along the guide slowly.
Do not make an impact on the HDD/SSD. Wait at least 30 seconds
before removing the HDD. Removing the failed HDD during its
motor rotating may damage other HDDs and cause unexpected
failures.
2
Install the same specification HDD/SSD with failed HDD/SSD.
Otherwise, the HDD/SSD may not be rebuilt correctly or may incur
abnormal operation.
Replacing parts
Hitachi Compute Rack 220H CRU Replacement Guide
3
4
4-3