Preparing For Use; Attaching The Brush Head - Sonicare HX4872 User Manual

4235 020 00392 16-12-2005 08:51 Pagina 6
ENGLISH
6
C
C
1
2
C

Preparing for use

Attaching the brush head

1 Align the bar on the brush head with the notch on the handle
and slide the brush head onto the handle.
2 Screw the brush head nut clockwise until it's firmly tightened. If
the brush head rattles when in use, tighten the nut further.
3 Remove the travel cap from your brush head.
Charging
◗ Sonicare comes partially charged and ready for use, but we highly
advise that you charge it for a total of 21 hours during the first
few days of use.
1 To charge your Sonicare, place the handle in the charger base
with the Sonicare logo facing towards you to ensure the handle
properly fits (slots) in the charger. Once the handle is placed in
the charger base, the power button light should illuminate or
blink to indicate charging is taking place.
Do not attempt to force the handle into the charger; this will cause
damage.
Older model Sonicare handles without the slotting feature will not fit in
this new charger base and do not charge effectively. Do not attempt to
force a handle without the slotting feature into this charger base, as this
will cause damage.
◗ Sonicare handles with the slotting feature can be charged
effectively in most older Sonicare charger bases. (Note; these
handles are not compatible with charger model TX-I).
It is recommended that you keep your Sonicare in the charger base
when not in use to maintain a full battery charge. After the initial
charging period of 21 hours, it takes 15 hours charging time to reach
full charge level.There is no need to periodically discharge the handle.