Remington iCoffee Davinci Customer Care Manual page 9

BREWING HOT WATER
iCoffee's Single Serve Brewer is capable of producing hot water for whatever reason you
may choose (Hot chocolate, soup, cooking, etc.). To brew a cup of hot water, press the
"OPEN" ICON to release the UPPER JAW, then lower it back down to its original position
without adding a K-Style Cup. Place your cup on the DRIP TRAY, select the correct cup size
(4, 6, 8, 10, or 12) and press the BREW button.
BREWING ICED BEVERAGES
Craving an iced tea or iced coffee... no problem with iCoffee's Single Serve Brewer. Merely
place a tall cup* filled with ice on the DRIP TRAY PLATE, choose your favorite K-Style Cup
(coffee, tea or other), insert the K-Style Cup into the brewer as you normally would and
press the respective beverage size you want (4, 6, 8, 10, or 12 oz cup size). Note: Remember
that the ice will melt as your beverage is dispensed which will impact its strength. To offset
the additional water from the melted ice, you may want to consider adjusting your brew
size to a lower cup size.
*A special note about the type of cup to use for brewing over ice, never use a cup made of GLASS, the
glass could crack or break when the extremely hot beverage is automatically dispensed over the ice.
PURGING YOUR BREWER
Purging your brewer... what's that? We're glad you asked! If you haven't used your brewer
for a week or so, you probably want to get rid of the old water sitting inside the WATER
RESERVOIR and replace it with fresh water, so... you want to "Purge your Brewer"!
Here's what to do:
1. Remove the WATER RESERVOIR from the brewer (remove the lid, sit aside, then lift the
water reservoir from its base and the brewer).
2. Discard the water that's inside the reservoir, rinse it out and then fill it back up with fresh water.
3. Put the WATER RESERVOIR back on the brewer and replace the lid.
4. Place a cup on the drip tray.
5. Turn the brewer on, press the "OPEN" ICON to release the UPPER JAW then immediately
lower it back down to its original position without inserting a K-Style Cup. When the
READY light illuminates, press the BREW button.
6. Repeat step 5 above until all the water from the WATER RESERVOIR has been depleted,
and the ADD WATER light is illuminated, this will ensure the old water has been removed
from the brewer's INTERNAL TANK.
7. Congratulations, you have just purged your brewer of all the old water!
7