Adding Water - Remington iCoffee Davinci Customer Care Manual

Taste | Innovation | Technology
NOTE: After brewing a beverage, you'll notice that the iCoffee Single Serve Brewer will
prepare itself for the next brew cycle by pre-heating the water for the next brew. During this
process of pre-heating, you'll notice that, the "HEATING" light will be illuminated. Once the
water has been heated to the perfect temperature for brewing, the HEATING light will turn off
and the READY light will be illuminated.
5. Press the "OPEN" ICON to release the "UPPER JAW", remove the used beverage container
from the SINGLE SERVE CUP HOLDER and discard; careful it will be hot!
HOW TO STOP BREWING IN MID-CYCLE
If you need to stop the iCoffee Single Serve Brewer once a brew cycle has started, either
press the POWER BUTTON or BREW BUTTON to turn off the brewer. NOTE: Stopping a brew
cycle may result in less beverage in your cup the next time you brew.

ADDING WATER

Your iCoffee Single Serve Brewer is programmed to alert you whenever its time to add water
to the water RESERVOIR. You'll notice that the BLUE light in the WATER RESERVOIR will blink
and the ADD WATER LIGHT will be illuminated. When this occurs, you can fill the reservoir in
one of two ways. Remove the lid from the WATER RESERVOIR and set aside, then either:
- Remove the WATER RESERVOIR from the brewer, fill to the "MAX FILL LINE", and put it back
onto the brewer and replace the lid, or...
- Leave the WATER RESERVOIR attached to the brewer and merely fill the reservoir with
water to the "MAX FILL LINE" and replace the lid.
CAUTION: Never attempt to remove the WATER RESERVOIR from its base while in the brewing
process. If the WATER RESERVOIR is removed from its base, the brewer may not dispense the
desired amount of liquid.
6
TM