Remington iCoffee Davinci Customer Care Manual page 7

NOW YOU'RE READY TO BREW YOUR FAVORITE BEVERAGE!
OK, the brewer is on, the READY light is illuminated and you're all set to brew a cup of your
favorite beverage, so let's get started:
1. Place a cup or mug on the DRIP TRAY, press the "OPEN" ICON to release the brewer's
"UPPER JAW" section, insert your favorite K-Style Cup into the removable SINGLE SERVE
CUP HOLDER, close/lower the UPPER JAW back to its original position.
NOTE: If you want to enjoy a larger cup/travel mug/glass of your favorite brew, merely pull the
DRIP TRAY UNIT (tray and cover) from the brewer towards you and place your larger cup/travel
mug/glass directly below the drip spout.
NOTE: Do not remove the cover from any K-Style Cup. In addition, the SINGLE SERVE CUP
HOLDER has a sharp needle inside the chamber to puncture the K-Style Cup, so to avoid injury
from the needle, never put your fingers in the SINGLE SERVE CUP HOLDER.
2. Determine your desired beverage size (4, 6, 8, 10 or 12 oz cup) and press the
corresponding CUP SIZE BUTTON.
NOTE: The brewer's initial 'brew' setting is an 8 oz brew. By selecting another Brew size,
you truly can customize the strength of your favorite beverage! Once you have selected your
brew size, the Brewer will remember that selection.
3. Now, press the BREW button to brew your favorite beverage.
NOTE: You'll notice that the brewer's LED light in the dispense area will illuminate as your
beverage is being brewed.
CAUTION: The hot water temperature inside the SINGLE SERVE CUP HOLDER is extremely hot,
therefore, never open the JAW areas while brewing, as doing so may result in injury.
4. When the brewer has finished the brew, the LED light in the dispense area will
extinguish. Carefully remove your cup from the DRIP TRAY and enjoy your perfectly
brewed beverage! Careful though, it will be HOT!
ons
5