Let's Get Started - Remington iCoffee Davinci Customer Care Manual

Taste | Innovation | Technology

LET'S GET STARTED!

Unpacking and preparing your iCoffee Single Serve Brewer.
Before you can make your first cup of your favorite beverage, you need to get the
brewer ready to be used:
1. Remove all packing tape, packaging, and stickers from the brewer and wipe clean
with a soft water-dampened cloth.
2. Plug the brewer into a grounded outlet.
3. Place a large cup or mug (10 oz. minimum) on the DRIP TRAY directly below the
JAW area.
4. Remove the WATER RESERVOIR LID from the WATER RESERVOIR, set aside. Remove
the WATER RESERVOIR from the brewer by pulling it straight up from its base.
5. Wash the WATER RESERVOIR & LID with warm soapy water, rinse well and dry with
a soft cloth.
6. Fill the WATER RESERVOIR container with water (tap, bottled or filtered) to the
"MAX FILL LINE" and then return it back to its base, on the brewer, along with its lid.
7. Press the POWER BUTTON. At this point, the water from the WATER RESERVOIR will
automatically be pumped into the Brewer's INTERNAL TANK and the water heating
process will begin. This process will take several minutes.
8. Once the water is heated the READY Light will be illuminated.
9. Press the "OPEN" ICON
merely press it back down to its original position to close.
10. Press the 10 oz Cup Size Button, make sure your mug is in place on the DRIP TRAY
and press the BREW button.
11. The brewer will run the heated water through its components and dispense hot
water into your cup. When the cycle is complete, merely discard the dispensed
water from your cup.
2
TM
the UPPER JAW will automatically raise, at this point