Installation; Pole; Box With Electronic Circuit Board - Prointegra Meteobot User Manual

3 Installation

In this section the installation of Meteobot Pro is described. Because Meteobot Mini has
fewer components, they can be installed higher on the pole.

3.1 Pole

 Use a pole (metal tube) with diameter – 4-5 cm, and length – for Meteobot Pro: 3 m,
for Meteobot Mini – 1,50 m;
 For Meteobot Pro: hammer the pole 1 m in the ground; for Meteobot Mini – 70 cm;
 IMPORTANT: Should be perfectly vertical!

3.2 Box with electronic circuit board

 Install the box by clamping the two metal planks on its back to the pole with two hose
clamps φ40-60 mm;
 For Meteobot Pro: the lower edge of the box should be 75 cm below the top of the
pole; the box should be facing South;
 For Meteobot Mini: the lower edge of the box should be 40 cm below the top of the
pole; the box should be facing North.
Page 7 / 22