Uninstallation; Uninstalling The Weather Station; Uninstalling A Sensor; Replacing The Battery - Prointegra Meteobot User Manual

8 Uninstallation

When uninstalling the weather station or any components, observe the instructions below.

8.1 Uninstalling the weather station

 Open the lid of the box with a straight screwdriver (-);
 Unscrew the cable glands;
 Unscrew one of the solar panel cables from the electronic circuit board and INSULATE
it. Then unscrew the other cable and INSULATE it as well. Withdraw the solar panel
cables from the box;
 Remove the cable shoes from the battery terminals. Take the battery out of the box;
 Unscrew the cables of one of the sensors and withdraw them from the box. Repeat
that for all sensors;
 Uninstall the components from the pole.
IMPORTANT: To take a sensor of the ground, dig it out. Do NOT pull it by the cable.

8.2 Uninstalling a sensor

 Open the lid of the box with a straight screwdriver (-);
 Unscrew one of the solar panel cables from the electronic circuit board and INSULATE
it. Then unscrew the other cable and INSULATE it as well;
 Remove the cable shoes from the battery terminals. Take the battery out of the box;
 Unscrew the cables of the sensor. Unscrew the respective cable gland. Withdraw the
sensor cables from the box.
IMPORTANT: If you do not replace the sensor right away, fit a short piece of cable in
the cable gland and tighten it. Otherwise water may get into the box and may damage
the electronic circuit board;
 Uninstall the sensor.
IMPORTANT: To take a sensor of the ground, dig it out. Do NOT pull it by the cable;
 Put the battery back in the box and connect the cable shoes to the terminals.
IMPORTANT: Connect the red cable shoe to the red terminal (+) and the blue cable
shoe to the black terminal (-);
 Connect the solar panel cables to the electronic circuit board one by one.
IMPORTANT: Be careful not to connect them to each other! If you make a short circuit,
the solar panel may get damaged;
 Close the lid, making sure it fits tightly to the box;
 Bind the slack cables to the pole with cable ties.

8.3 Replacing the battery

 Open the lid of the box with a straight screwdriver (-);
 Unscrew one of the solar panel cables from the electronic circuit board and INSULATE
it. Then unscrew the other cable and INSULATE it as well;
 Remove the cable shoes from the battery terminals. Take the battery out of the box;
 Put a new battery in the box and connect the cable shoes to the terminals.
IMPORTANT: Connect the red cable shoe to the red terminal (+) and the blue cable
shoe to the black terminal (-);
Page 19 / 22