Leaf Wetness Sensor; Connecting The Cables - Prointegra Meteobot User Manual

3.9 Leaf wetness sensor

 Fasten the sensor with cable ties near the plant, whose leaf wetness will be measured;
 The incline relative to the ground should be about 30⁰;
 IMPORTANT: If the sensor gets dirty, clean it with a soft wet cloth;
 IMPORTANT: Be careful not to scratch the sensor during installation or cleaning.

3.10 Connecting the cables

 Open the lid of the box with
a straight screwdriver (-);
 Insert the sensor and panel
cables in the box through
the cable glands (the round
openings) in the lower end
of the box;
 IMPORTANT:
cable should pass through a
cable gland.
water may penetrate the
glands and the moisture
may damage the electronic
circuit board.
Only one
Otherwise
Page 12 / 22